 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes. Failure to
comply may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Disconnect middle rear marker light
connector from connector P56.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P56.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
(7) If 12 VDC is not present, repair wire 489
from connector P56 to splice (refer to Table
2-12.11. M1085/M1086/M1089/M1096
Rear Marker Lights Splices) (para 2-45)
and go to step 12 of this fault if required
or replace M1086/M1089 rear lights cable
assembly (para 7-104) or M1085/M1096
rear lights cable assembly (para 7-84)
and go to step 1 of this fault.
(8) Connect middle rear marker light connector
to connector P56.
Table 2-12.11. M1085/M1086/M1089/M1096
Rear Marker Light Splices
Model
Splice
M1085/M1086/M1096
E15
M1089
E50
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals