 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes. Failure to
comply may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Disconnect LH intermediate marker light
connector from connector P94.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P94.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
(7) If 12 VDC is not present, repair wire 489
from connector P94 to splice (refer to Table
2-12.6. M1085/M1086/M1089/M1096
Intermediate Marker Light Splices) (para
2-45) and go to step 5 of this fault if
required or replace M1086/M1089 rear
lights cable assembly (para 7-104) or
M1085/M1086 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
Table 2-12.6. M1085/M1086/M1089/M1096
Intermediate Marker Light Splices
Model
Splice
M1085/M1086/M1096
E64
M1089
E49
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals