CONTINUITY TEST - TM-9-2320-366-20-11025

TM 9-2320-366-20-1

CONTINUITY TEST

(1) Remove nut, lockwasher, terminal lug, and

lockwasher from marker light screw. Discard

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to terminal lug (refer to Table 2-12.5.

M1085/M1086/ M1089/M1096

Intermediate, Side, and Rear Marker Light

Terminal Lugs).

(4) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(5) If continuity is not present, repair wire (Refer

to Table 2-12.5. M1085/M1086/ M1089/

M1096 Intermediate, Side, and Rear

Marker Light Terminal Lugs) (para 2-45) or

replace M1086/M1089 rear lights cable

assembly (para 7-104) or M1085/M1096

rear lights cable assembly (para 7-84).

(6) If continuity is present, replace marker

light (para 7-38).

(7) Install lockwasher, terminal lug,

lockwasher, and nut on marker light screw.

(8) Connect marker light connector to

connector (refer to Table 2-12.5. M1085/

M1086/ M1089/M1096 Intermediate,

Side, and Rear Marker Light Terminal Lugs).

Table 2-12.5. M1085/M1086/M1089/ M1096 Intermediate, Side, and Rear Marker Light Terminal Lugs

Marker Light

Terminal Lug

M1089

M1085/M1086/M1096

Wire 3089 from Terminal Lug TL88 Wire

3089 from Terminal Lug TL88

LH Intermediate

TL88

to Terminal Lug TL90

Wire 3094 from Terminal Lug TL15 Wire

3094 from Terminal Lug TL15

LH Side

TL15

to Terminal Lug TL16

Wire

3094 from Terminal Lug TL30

LH Rear

TL16