 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug, and
lockwasher from marker light screw.
Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug (refer to Table 2-12.1.
M1093/M1084/M1090/M1090/M1092/
M1093 Side and Rear Marker Light
Terminal Lugs).
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire
(refer to Table 2-12.1. M1093/M1084/
M1090/M1090/M1092/M1093 Side and
Rear Marker Light Terminal Lugs)
(para 2-45) or replace rear lights cable
assembly (para 7-84).
(6) If continuity is present, replace marker
light (para 7-38).
(7) Install lockwasher and terminal lug on
marker light screw with lockwasher and
nut.
Table 2-12.1. M1083/M1084/M1090/M1092/M1093/M1094
Side and Rear Marker Light Terminal Lugs
Marker Light
Connector
Wire Segment
Wire 3094 from Terminal Lug TL15
LH Side
TL15
to Terminal Lug TL16
LH Rear
TL16
Replace Marker Light (para 7-38)
Wire 3094 from Terminal Lug TL31
Left Rear
TL30
to Terminal Lug TL30
Middle Rear
TL31
Replace Marker Light (para 7-38)
Right Rear
TL32
Replace Marker Light (para 7-38)
RH Rear
TL20
Replace Marker Light (para 7-38)
Wire 3095 from Terminal Lug TL19
RH Side
TL19
to Terminal Lug TL20
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals