 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Disconnect marker light connector from
connector (refer to Table 2-12. M1083/
M1084/M1090/M1092/M1093/M1094
Side and Rear Marker Light Connectors).
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector (refer to Table 2-12.
M1083/M1084/M1090/M1092/M1093/
M1094 Side and Rear Marker Light
Connectors).
(4) Connect negative (-) probe of multimeter
to ground.
Table 2-12. M1083/M1084/M1090/M1092/M1093/
(5) Position main light switch to SER DRIVE
M1094 Side and Rear Marker Light Connectors
(TM 9-2320-366-10-1) and note reading
on multimeter.
Marker Light
Connector
Wire 489 Segment
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
LH Side
P85
Connector
P85
to
Splice
(7) If 12 VDC is not present, repair wire 489
LH Rear
P86
Connector
P86
to
Splice
(refer to Table 2-12. M1083/M1084/
Left Rear
P54
Connector
P54
to
Splice
M1090/M1092/M1093/M1094 Side and
Middle Rear
P56
Connector
P56
to
Splice
Rear Marker Light Connectors)
Right Rear
P58
Connector
P58
to
Splice
(para 2-45) or replace rear lights cable
assembly (para 7-84).
RH Rear
P89
Connector
P89
to
Splice
RH Side
P88
Connector
P88
to
Splice
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals