 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Loosen four captive screws in lamp
mounting panel.
(2) Remove lamp mounting panel from lighted
indicator display housing.
(3) Remove two rear brake air indicator lamps
from printed circuit board.
(4) Set multimeter to ohms.
(5) Check continuity through each rear brake
air indicator lamp and note reading on
(6) If continuity is not present, replace rear
brake air indicator lamps (para 7-16).
(7) If continuity is present, replace lighted
indicator display (para 7-16).
(8) Install two rear brake air indicator lamps in
printed circuit board.
(9) Install lamp mounting panel in lighted
indicator display housing.
(10) Tighten four captive screws in lamp
mounting panel.
(11) Connect lighted indicator display connector
to connector PX7.
(12) Position lighted indicator display in
instrument panel assembly with four
screws.
(13) Tighten four screws to 6-10 lb-in. (1 Nm).
(14) Connect batteries (para 7-57).
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals