|
|
TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Remove instrument panel assembly for access
(para 7-15).
(2)
Disconnect connector PX1 from radiator fan
off switch.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter to
connector PX7-26.
(5)
Connect negative (-) probe of multimeter to
connector PX1-6 and note reading on
multimeter.
(6)
If continuity is not present, repair wire 1814
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector PX1-2.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, repair wire 3023
(para 2-45) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III dashboard
cable assembly (para 7-11).
(5)
If continuity is present, replace radiator fan off
switch (para 7-18).
(6)
Connect connector PX1 to radiator fan off
switch.
(7)
Install instrument panel assembly (para 7-15).
(8)
Connect lighted indicator display to connector
PX7.
(9)
Position lighted indicator display in instrument
panel assembly with four screws.
(10)
Tighten four screws to 6-10 lb-in. (1 Nm).
(11)
Connect batteries (para 7-57).
2-487
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |