|
|
TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Remove four screws from lighted indicator
display.
(2)
Remove lighted indicator display from
instrument panel assembly.
(3)
Disconnect connector PX7 from lighted
indicator display.
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter to
lighted indicator display terminal 2.
(6)
Connect negative (-) probe of multimeter to
lighted indicator display terminal 17 and
note reading on multimeter.
(7)
If continuity is not present, go to step 3 of
this fault.
2-435
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |