|
|
TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector PX26 socket 6.
(3) Connect negative (-) probe of multimeter
to connector PX26 socket 4 and note
reading on multimeter.
(4) If continuity is not present, repair wire 3083
from connector PX26 socket 6 to socket 4
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(5) If continuity is present, repair wire 3083
connector PX26 socket 4 to connector J31
pin 16 (para 2-45) or replace WTEC II
dashboard cable assembly (para 7-10) or
WTEC III dashboard cable assembly (para
7-11).
(6) Connect connector PX26 to frequency ECU
connector.
Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |