 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
RESISTANCE TEST
(1) Raise cab (TM 9-2320-366-10-1)
(2) Set multimeter to ohms.
(3) Disconnect connector P32 from engine oil
pressure transmitter connector.
(4) Connect positive (+) probe of multimeter to
engine oil pressure transmitter pin 2.
(5) Connect negative (-) probe of multimeter to
known good ground and note reading on
multimeter.
(6) If 202-243 ohms resistance is not present,
replace engine oil pressure transmitter
(para 7-49).
NOTE
Perform steps (7) through (9) if 202-243
ohms resistance is not present.
(7) Connect connector PX6 to engine OIL
PRESS gage connector.
(8) Connect connector clamp to engine OIL
PRESS gage connector.
(9) Install instrument panel assembly
(para 7-15).
CONTINUITY TEST
(1) Connect connector P32 to engine oil
pressure transmitter connector.
(2) Lower cab (TM 9-2320-366-10-1).
(3) Disconnect connector J31 from connector
P31.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
connector PX6 pin 4.
(6) Connect negative (-) probe of multimeter to
connector J31 pin 11 and note reading on
multimeter.
(7) If continuity is not present, repair wire 36
from connector PX6 pin 4 to connector J31
pin 11(para 2-45) or replace WTEC II
dashboard cable assembly (para 7-10) or
WTEC III dashboard cable assembly
(para 7-11).
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals