 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
CONTINUITY TEST
(1)
Disconnect connector J31 from connector
P31.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter
to connector PX11 pin 4.
(4)
Connect negative (-) probe of multimeter
to connector J31 pin 20 and note reading on
multimeter.
(5)
If continuity is not present, repair wire
33 from connector PX11 pin 4 to connector
J31 pin 20 (para 2-45) or replace WTEC II
dashboard cable assembly (para 7-10) or
WTEC III dashboard cable assembly
(para 7-11).
(6)
If continuity is present, repair wire 33 from
connector P31 socket 20 to connector P41
(para 2-45) or replace engine control
cable assembly (para 7-80).
(7)
Connect connector J31 to connector P31.
(8)
Connect connector PX11 to WATER
TEMP gage connector.
(9)
Connect connector clamp on WATER
TEMP gage connector.
(10)
Install instrument panel assembly (para 7-15).
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals