 |
|||
|
|
|||
|
Page Title:
RESISTANCE TEST |
|
||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
RESISTANCE TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter
to connector PX11 pin 4.
(3)
Connect negative (-) probe of multimeter
to a known good ground and note
reading on multimeter.
(4)
If less than 750 ohms is present, go to
step 3 of this fault.
(5)
If greater than 750 ohms is present,
replace WATER TEMP gage (para 7-14).
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals