 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Connect connector P82 to fuel level
sensor.
(2) Connect connector clamp on fuel level
sensor.
(3) Disconnect connector J43 from
connector P43.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to connector J43 socket 3.
(6) Connect negative (-) probe of multimeter
to PX9 pin 4 and note reading
on multimeter.
(7) If continuity is not present, repair wire 28
from connector PX9 pin 4 to connector
J43 socket 3 (para 2-45) or replace
WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(8) If continuity is present, repair wire 28
from connector P43 pin 3 to connector
P82 pin 1(para 2-45) or replace start and
charging cable assembly (para 7-132).
(9) Connect connector J43 to connector P43.
(10) Connect connector PX9 to fuel gage
connector.
(11) Connect connector clamp on fuel gage
connector.
(12) Install instrument panel assembly
(para 7-15).
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals