 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector PX17 socket 1.
(3) Connect negative (-) probe of multimeter
to relay K2 socket 86 on PDP and note
reading on multimeter.
(4) If continuity is not present, repair wire
1548 from connector PX17 socket 1
to relay K2 socket 86 on PDP (para
2-45) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(5) If continuity is present, repair wire 1586
from connector PX17 socket 5 to circuit
breaker CB70 socket 4 on PDP (para 2-45)
or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6) Connect connector PX17 to master power
switch connector.
(7) Install instrument panel (para 7-15).
(8) Install relay K2 in PDP.
(9) Install PDP cover (para 16-2).
(10) Connect batteries (para 7-57).
Change 1
2-284.13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals