 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Remove adhesive from solenoid right
terminal stud.
(2) Connect batteries (para 7-57).
(3) Set multimeter to volts DC.
(4) Connect positive (+) probe of multimeter
to terminal lug TL26.
(5) Connect negative (-) probe of multimeter to
ground.
(6) Lower cab (TM 9-2320-366-10-1).
(7) Position master power switch to on
(TM 9-2320-366-10-1).
(8) Press starter pushbutton
(TM 9-2320-366-10-1) and note reading on
multimeter.
(9) If 24 VDC is not present, go to 4 of this
fault.
(10) If 24 VDC is present, replace starting motor
(para 7-7).
(11) Position master power switch to off
(TM 9-2320-366-10-1).
Change 1
2-169
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals