Installation. - TM-9-2320-279-20-10922

9-2320-279-20-1

Electrical System Maintenance Instructions (Cont)

7-67.2. REAR CLEARANCE MARKER LIGHTS AND BRACKET REMOVAL/INSTALLATION

(M984E1) (CONT).

(5) Disconnect wire (10) from

connector (11).

(6) Remove two screws (12),

clamps (13), and

harness (14) from

bracket (15).

(7) Remove two screws (16),

four lockwashers (17), two

nuts (18), and bracket (15)

from towing support

assembly (19).

Installation.

(1) Install bracket (1) on towing

support assembly (2) with

two screws (3), four

lockwashers (4), and two

nuts (5).

NOTE

Replace plastic cable ties as

necessary.

(2) Install harness (6) on

bracket (1) with two

clamps (7) and screws (8).

(3) Connect wire (9) to

connector (10).

NOTE

All three clearance lights are installed the same way.

(4) Install gasket (11) and lampholder (12) on bracket (1) with two

screws (13).

(5) Install lamp (14),

(6) Install lens (15) on lampholder (12) with two screws (16),

(7) Connect wire (17) to

connector (18).

c. Follow-on Maintenance.

(1) Connect batteries (para 7-91).

(2) Check operation of rear

clearance lamps

(TM 9-2320-279-10).

END OF TASK

7-240