HIGH BEAM INDICATOR LIGHT ASSEMBLY REMOVAL/INSTALLATION.

TM 9-2320-279-20-1

Electrical System Maintenance Instructions (Cont)

7-32. HIGH BEAM INDICATOR LIGHT ASSEMBLY REMOVAL/INSTALLATION.

This task covers:

a. Removal

c. Follow-on Maintenance

b. Installation

INITIAL SETUP

Models

References

All

None

Test Equipment

Equipment Condition

TM or Para

Condition Description

None

Para 7-19

Instrument panel

Special Tools

removed.

None

Special Environmental Conditions

Supplies

None

Connector, electrical, butt, Item 19,

General Safety Instructions

Appendix C

None

Personnel Required

MOS 63S, Heavy wheel vehicle mechanic

Removal.

(1)

Pull high beam indicator light socket (1) out of

receptacle (2).

(2) Remove shield (3), receptacle (2), and

lockwasher (4) from instrument panel (5).

NOTE

Some trucks do not have butt connectors.

(3) Cut wire (6) at electrical butt connector

(7), and remove high beam indicator

light socket (1).

(4) Remove buld (8) from high beam

indicator light socket (1).

Installation.

(1)

Install shield (3) with lockwasher (4) and

receptacle (2) on instrument panel (5).

(2)

Insert wires (6) in electrical butt

connector (7).

(3)

Install bulb (8) in high beam indicator

light socket (1) and push high beam

indicator light socket into receptacle (2).

Follow-on Maintenance.

(1)

Install instrument panel (para 7-19).

(2)

Check operation of turn indicator

light (TM 9-2320-279-10).

END OF TASK

7-100

Change 4