 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-279-20-1
Electrical System Maintenance Instructions (Cont)
DIODE REMOVAL/INSTALLATION.
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Models
References
All
None
Test Equipment
Equipment Condition
None
TM or Para
Condition Description
TM 9-2320-279-10 Engine side panel
Special Tools
removed.
None
Batteries disconnected.
Supplies
Special Environmental Conditions
Sealant, RTV200 Electrical, Item 45.05,
None
Appendix C
Personnel Required
General Safety Instructions
MOS 63S, Heavy wheel vehicle mechanic
None
a.
Removal.
(1) Remove nut (1), washer (2),
and disconnect wire (3) from
diode (4).
(2) Remove nut (5), lockwasher (6),
washer (7), and diode (4) from
sender mounting bracket (8).
b.
Installation.
(1) Install diode (4) on bracket (8)
with washer (7),
lockwasher (6), and nut (5).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets on
skin or clothing, wash immediately
with soap and water.
NOTE
Apply electrical sealant to exposed wire
connectors after installing connectors.
(2)
Connect wire (3) to diode (4)
with washer (2) and nut (1).
Change 5
7-72.1/(7-72.2 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals