|
|
TM 9-2320-279-20-1
Electrical System Maintenance Instructions (Cont)
NOTE
There are two models of wiring
harnesses. Model A has no boot.
Model B has a boot covering back
side of connector. Perform steps
(5.1 and 7.1) for Model B only.
(4)
Install two wire harnesses
(11 and 12) in ENGINE
HIGH IDLE box (3) with two
grommets (13), rings (14),
and caps (15).
(5) Install two electrical butt
connectors (16).
(5.1) Install boot (16.1) over wires
(18).
(6) Install four pins (17) on
wires (18).
(7) Install four pins (17) in
connector (19).
(7.1) Slide boot (16.1) over
connector (19).
7-38.1/(7-38.2 blank)
Change 3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |