Installation. - TM-9-2320-279-20-10666

TM 9-2320-279-20-1

Electrical System Maintenance Instructions (Cont)

7-8. STARTER MOTOR REMOVAL/INSTALLATION (CONT).

(2)

Support starter motor (2) and remove

three screws (3) and lockwashers (4).

(3) Remove two screws (5), washers (6),

spacer (7), and locknuts (8) from starter

end support bracket (9).

(4) Pull starter motor (2) forward to remove

it from flywheel housing (10).

Installation.

NOTE

Check flywheel ring gear for broken or

damaged teeth before installing starter

motor.

(1)

Insert starter motor (1) in

flywheel housing (2).

(2)

Install two screws (3),

washers (4), spacer (5), and

locknuts (6) on starter end

support bracket (7).

(3)

Secure starter motor (1) with

three screws (8) and

lockwashers (9).

(4)

Tighten locknuts (6).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

NOTE

Apply electrical sealant to exposed wire

connectors after installing connectors.

(5)

Connect starter motor cables

and solenoid wires.

(6) Tighten screws (8).

Follow-on Maintenance.

(1) Connect batteries (para 7-91).

(2) Check starter motor operation

(TM 9-2320-279-10).

(3) Install engine side panel (TM 9-2320-279-10).

(4) Close engine cover (TM 9-2320-279-10).

END OF TASK

7-14

Change 5