 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-279-20-1
Electrical System Maintenance Instructions (Cont)
(6)
Position alternator (5) on
mounting brackets (6). Install
mounting screw (7), washer (8)
and nut (9). Do not tighten
nut.
NOTE
If truck is equipped with 65 amp
alternator, perform step (7).
If truck is equipped with 130 amp
alternator, perform step (7.1).
(7)
Place rear side of mounting ear
(10) against brace (11). Install
adjusting screw (12) with
lockwasher (13) and washer
(14) through brace (11) and
into mounting ear (10). Do not
tighten screw (12).
(7.1) Place rear side of mounting
ear (10) against brace (11).
Install adjusting screw (12)
with lockwasher (13),
washer (14), and nut (14.1)
through brace (11) and into
mouting ear (10).
Do not tighten screw (12).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
NOTE
Apply electrical sealant to exposed wire
connectors after installing connectors.
(8)
Install three wires (15),
lockwashers (16),
and nuts (17).
c.
Follow-on Maintenance.
(1)
Install alternator belts (para 6-15).
(2)
Connect batteries (para 7-91).
(3)
Test alternator (para 7-2).
END OF TASK
Change 5
7-6.1/(7-6.2 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals