WINDSHIELD WASHERS DO NOT OPERATE.

TM 9-2320-279-20-1

Troubleshooting Malfunctions (Cont)

2-15. TROUBLESHOOTING INSTRUCTIONS (CONT).

Table 2-9.

Troubleshooting (Cont)

Malfunction

Test or Inspection

Corrective Action

ELECTRICAL SYSTEM (CONT)

21. WINDSHIELD WASHERS DO NOT OPERATE.

Step 1.

Remove left and right heater compartment covers (para 16-11). Set multimeter to test for

ohms. Check circuit breaker No. 12 for continuity across contacts.

If no continuity, replace circuit breaker No. 12 (para 7-43).

If continuity, go to step 2.

NOTE

When electric wiper/washer control switch is pressed in all positions except OFF, windshield

washer is on.

Step 2.

Remove side panel (para 7-39). Set multimeter to test for 24 vdc. Place negative (--) probe

and touch positive (+) probe to socket red wire (wire 1917) on electric wiper/washer control

switch connector. Turn engine start switch to ON position. Meter should show 24 vdc.

If 24 vdc is not present, replace electric wiper/washer harness (para 18-9.4).

If 24 vdc is present, go to step 3.

Change 6