|
|
TM 9-2320-211-34-2-1
Disassembly.
c.
FRAME
1
M o u n t differential carrier assembly (1) in holding device.
1.
U s i n g center punch and hammer, mark positions of two caps (2) to bearing
2.
s a d d l e s ( 3 ) . C a p s must be put back in same positions.
Take out two safety wires (4). Throw away safety wires.
3.
T a k e off two adjusting nut locks (6).
Take out two screws (5).
4.
T a k e out four screws and flat washers (7).
5.
T a p on sides of two caps (2) to loosen them. Take off caps.
6.
GO TO FRAME 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |