|
|
TM 9-2320-211-34-2-1
Assembly of Subassemblies.
g.
NOTE
K e e p all parts clean and protected from dust and
d i r t . Coat all bearings and oil seals with multipurpose
l u b r i c a n t when putting them in.
Coat all gears and shafts with e n g i n e lubricating
oil . C o a t shafts and bores of gears with white lead
pigment.
( 1 ) Rear output bearing retainer cap a n d f r o n t c o v e r .
FRAME 1
1.
P r e s s rear output shaft seal (1) into rear output shaft bearing retainer
cap (2).
2.
P u t shaft pin seal (3) in transfer case front cover (4).
END OF TASK
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |