FRAME 2 - TM-9-2320-211-34-2-10497

TM 9-2320-211-34-2-1

FRAME

NOTE

W h e n checking sprags, anvil and spindle ends of micro-

meter and flat back of sprag must all rest on a flat

s u r f a c e as shown in view A.

Since wear on all sprags in any one sprag unit will be

t h e same, it is only necessary to check five sprags in

e a c h assembly.

M e a s u r e five sprags (1) as shown in view A. If three or more sprags are

w o r n to 0.375 inch or smaller, put new sprags in sprag unit.

M e a s u r e five sprags (2) as shown in view B. I f three or more sprags are worn

m o r e than 1/16 inch on the polished edge, put new sprags in sprag unit.

END OF TASK

8-67