|
|
TM 9-2320-211-34-2-1
FRAME 2
NOTE
Readings must be within limits given in table 8-12.
The letter L shows a loose fit. I f readings are not
w i t h i n given limits, t h r o w away parts and get new
ones.
1.
M e a s u r e outside diameter of shaft (1).
2.
M e a s u r e width of three grooves (2).
M e a s u r e outside diameter of hole (3).
3.
M e a s u r e inside diameter of shifter bore in housing (4).
4.
5.
M e a s u r e fit of shifter shaft (1) in shifter bore (4).
GO TO FRAME 3
NOTE
CHECK ONLY THOSE PARTS WHICH ARE CALLED OUT.
PARTS WITHOUT CALLOUTS ARE SHOWN ONLY FOR
REFERENCE PURPOSES.
High and Low Range Shifter Fork Shaft Wear Limits
Size and Fit
of New Parts
Wear Limit
Index Number
Item /Point of Measurement
(inches)
(inches)
1
O u t s i d e diameter of shaft
2.9945 to 0.9955
0.9945
Groove width (under
2
0.0005 to 0.015
0.002
0.4375-inch
diameter
ball)
Hole diameter
3
0 . 4 9 5 to 0.500
0.503
4
S h i f t e r bore in housing
0.9995 to 1.0015
1.0025
0.0045 to 0.00070L
0.010L
Shifter shaft in shifter
1 and 4
bore
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |