|
|
TM 9-2320-211-34-2-1
c.
Replacement.
FRAME 1
1.
Put hardening sealer on outside of oil seal (1). Pack inside lip of seal
w i t h small amount of grease.
2.
U s i n g hammer and block of wood, drive oil seal (1) into place in rear out-
put shaft cover (2). Lip of oil seal must face transmission case (3).
3.
Put rear output shaft cover gasket (4) and cover (2) with oil seal (1) in
p l a c e on transmission case (3). Aline oil holes in transmission case, gas-
ket, and cover.
P u t in and tighten four screws (5) and lockwashers (6) to 65 to 75 pound-
4.
feet.
GO TO FRAME 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |