 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-20-3-2
Tachograph Adjustment.
d.
NOTE
Personnel making tachograph adjustments must
know how to figure out chart recordings. Refer
to para 20-11 for these instructions.
TOOLS:
Flat-tip screwdriver
None
SUPPLIES:
PERSONNEL: One
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
(1) Preliminary procedure. Open tachograph. Refer to para 20-10b
(1), frame 1.
(2) Adjusting stop and go stylus.
FRAME
1
1.
If base line reads too high on chart as shown, turn adjusting screw left.
2.
If base line reads too low as shown, turn adjusting screw right.
Close tachograph. Refer to para 20-10c (3), frame 4.
3.
4.
Start engine, let it run for five minutes, then drive truck for at least
five minutes. Refer to TM 9-2320-211-10.
Open tachograph. Refer to para 20-10b (1) frame 1.
5.
Read stop and go field on chart for correct base line recording as shown.
6.
NOTE
Follow-on Maintenance Action Required:
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals