Section IV. DATA PLATES

TM 9-2320-211-20-3-2

19-14. VEHICLE DATA PLATES REMOVAL AND REPLACEMENT.

NOTE

Data plates are mounted with screws, rivets, or

adhesive. This task shows one of each type.

TOOLS: For screw mounted plates:

Cross-tip screwdriver (Phillips type)

For drive screw and solid rivet mounted plates:

1/2-inch cold cut chisel

8-ounce ballpeen hammer

4-inch center punch (for drive screws)

Drill, electric (for drive screws)

1/4-inch drill bit (for drive screws)

1/8-inch punch (for rivets)

Blind hand riveter (for rivets)

For adhesive mounted plates:

Flat-tip screwdriver

SUPPLIES: Rivets

Drive screws

Solvent, dry cleaning, type II (SD-2), Fed. Spec PD-680

(for adhesive--held plates)

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.