 |
|||
|
|
|||
|
Page Title:
Power takeoff dump control rod and power takeoff connecting rod shaft adjustment. |
|
||
| ||||||||||
|
|
 TM 9-2320-211-20-3-2
Power takeoff dump control rod and power takeoff connecting rod
(3)
shaft adjustment.
1.
Put dump control hand lever (1) in RAISE position and step
Soldier B
down on clutch pedal (2).
Using pliers, take out cotter pin (3) and pull out clevis pin
2.
Soldier A
(4).
Pull power takeoff dump control rod (5) towards back of truck
3.
as far as it will go.
4.
Check that clevis pin holes in clevis (6) aline with hole in
power takeoff relay lever (7). If holes are alined, do step 6.
If holes are not alined, do clevis adjustment for clevises (6 and 8).
5.
Refer to para 18-17b. Then do step 6.
Put clevis pin (4) through clevis (6) and power takeoff relay
6.
lever (7). Put in cotter pin (3) and bend open ends of cotter
pin.
Put dump control hand lever (1) in LOWER position and let go
7.
Soldier B
of clutch pedal.
8.
Check that all levers and rods move freely.
Soldier A
Do adjustment check again. Refer to para 18-17a.
9.
END OF TASK
18-82
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals