Hand lever rod and transfer motion rod adjustment.

TM 9-2320-211-20-3-2

(2)

FRAME 1

Using pliers, take out cotter pin (1) and clevis pin (2) on

Soldier A

power takeoff relay lever (3). Throw away cotter pin. Tell

soldier B when ready.

Unlock dump control hand lever lock (4) and put dump control

Soldier B

hand lever (5) in RAISE position.

Using pliers, take out cotter pin (6) and clevis pin (7). Throw

Soldier A

away cotter pin. Push relay lever (8) towards back of truck

as far as it can go.

Check that clevis pin holes in clevis (9) aline with clevis pin

hole in relay lever (8). If holes are alined, do step 6.

If holes are not alined, do clevis adjustment for clevises (9)

and (10). Refer to para 18-17b (1). Then do step 7.

Put clevis pin (7) through clevis (9) and relay lever (8).

Using pliers, put in cotter pin (6) and bend open ends of cotter

pin. Tell soldier B when ready.

Put clevis pin (2) through clevis (11) and power takeoff relay

lever (3). Put in new cotter pin (1) and bend open ends of

cotter pin.

Put dump control hand lever (5) in LOWER position.

Soldier B

Check that relay lever (8) moves toward front of truck without

Soldier A

binding.

END OF TASK

18-81