FRONT WINCH TENSION SHEAVE ASSEMBLY REMOVAL AND REPLACEMENT (TRUCK M543A2).

TM 9-2320-211-20-3-2

18-6. FRONT WINCH TENSION SHEAVE ASSEMBLY REMOVAL AND

REPLACEMENT (TRUCK M543A2).

18-inch hinged handle

TOOLS: Hoisting equipment

Breaker bar

Chain sling

3/4-inch wrench (2)

Offset screwdriver

SUPPLIES: None

PERSONNEL: None

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Removal.

FRAME 1

Put chain sling and hoist onto front winch and roller assembly (1) as shown.

Using hoist, take slack out of chain and cable.

Take off propeller shaft front universal joint from yoke on winch driveshaft.

Refer to Part 1, para 10-11.

Using 3/4-inch wrenches, unscrew and take off three screws and lock-

washers (2) and three nuts (3) on both sides of front winch and roller

assembly (1).

Using 3/4-inch wrenches, unscrew and take off three screws, lockwashers,

and flat washers (4) on both sides of front winch and roller assembly (1).

Using hoist, lift front winch and roller assembly (1) to clear front bumper

(5). Take off front winch and roller assembly (1).

TO FRAME 2