CHAPTER 18. WINCH, HOIST, AND CRANE ASSEMBLIES GROUP MAINTENANCE

TM 9-2320-211-20-3-2

WINCH, HOIST, AND CRANE ASSEMBLIES GROUP MAINTENANCE

Section I. SCOPE

18-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance

procedures for winch, hoist, and crane assemblies for which there are authorized

corrective maintenance tasks at the organizational maintenance level.

18-2. EQUIPMENT ITEMS NOT COVERED. All equipment items for which corrective

maintenance is authorized at the organizational maintenance level are covered in this

chapter.

Section II.

WINCH, HOIST, AND CRANE ASSEMBLIES

18-3. FRONT WINCH AND REAR WINCH BRAKE TESTS AND ADJUSTMENTS.

NOTE

This task is the same for the front winch and

rear winch on all trucks. This task is shown

for the front winch. There is no drag brake

adjustment for rear winch.

TOOLS :

9/16-inch wrench

Offset screwdriver

Leather gloves

None

SUPPLIES :

PERSONNEL :

Three

EQUIPMENT CONDITION :

Truck parked, engine off, handbrake set.

Refer to TM 9-2320-211-10.

Preliminary Procedure.

Release drum lock knob.