Replacement of Tie Rod Assembly.

TM 9-2320-211-20-3-2

FRAME 1

Put tie rod assembly (1) under truck. Make sure that tie rod end (2) with

left hand threads is on left side of truck.

2. Unscrew and take off nut (3).

3. Put tie rod end (2) into steering knuckle (4) and hold it in place.

4. Using 15/16-inch socket wrench with ratchet handle, screw on and tighten

nut (3).

5. Put cotter pin (5) through nut (3) and ball stud (6).

6. Using pliers, bend ends of cotter pin (5) around nut (3).

7. Do steps 2 through 6 again for other end of tie rod assembly (1).

8. Remove supports and lower front axle housing. Refer to Part 1, para 10-3.

NOTE

Follow-on Maintenance Action Required:

1. Adjust toe-in. Refer to para 14-3.

2. Lubricate tie rod assembly. Refer to

LO 9-2320-211-12.

END OF TASK