Cleaning. - TM-9-2320-211-20-3-20083

TM 9-2320-211-20-3-2

Cleaning.

NOTE

This task is for both inner and outer wheel

bearing cones.

FRAME 1

WARNING

Dry cleaning solvent is flammable. Do not use

near an open flame. Keep a fire extinguisher

nearby when solvent is used. Use only in well-

ventilated places. Failure to do this may result

in injury to personnel and damage to equipment.

CAUTION

Do not spin bearings at anytime. Spinning will

seriously damage bearings. After cleaning, keep

bearings clean and dry. Dirt and moisture can

damage bearings.

NOTE

All old lubricant must be taken off bearings during

cleaning. Do soaking and rapping steps over as

necessary to take off all old lubricant.

Using degreaser and solvent, soak bearing cone (1) to loosen lubricant.

If lubricant is left on bearing cone (1) after soaking, rap bearing cone

against heel of hand to loosen lubricant.

WARNING

Do not dry wheel bearing with compressed air.

Spinning bearings may explode and cause serious

injury to personnel.

Let wheel bearing cone (1) dry.

Using clean rags, wipe all old grease from hub (2).

END OF TASK