POWER DIVIDER-TO-REAR WINCH PROPELLER SHAFT REMOVAL AND REPLACEMENT (TRUCK M543A2).

TM 9-2320-211-20-3-1

10-12. POWER DIVIDER-TO-REAR WINCH PROPELLER SHAFT REMOVAL AND

REPLACEMENT (TRUCK M543A2).

TOOLS: General mechanic's tool kit

Rolling head prybar

Leather gloves

5-foot prybar

Torque wrench

150 pound-feet capacity

SUPPLIES: None

PERSONNEL: TWO

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Removal.

WARNING

Always jack up one wheel of the axle driven by

propeller shaft being taken out. Refer to para

10-3. This is to keep personnel from being hurt

by windup of shaft.

(1) Front propeller shaft and universal joints.

Working under truck with flat-tip screwdriver, open ends of two locking

clips (1).

Using 1/2-inch wrench, unscrew and take out four screws (2). Take out

two locking clips (1) and pull down front end of propeller shaft (3).

GO TO FRAME 2