FRAME 2 - TM-9-2320-211-20-3-10603

TM 9-2320-211-20-3-1

Check that contact points are not pitted or burned. If points are damaged,

throw assembly away.

NOTE

If plastic on four screws (1) is loose, use nail scribe or

finely-pointed awl to keep it from turning.

Using screwdriver, unscrew and take out and throw away four screws (1).

Put gasket (2) in place. Put upper body (3) and lower body (4) together.

Using drill and no. 36 drill bit and using screw holes (5) as guides, drill

holes through upper body (3).

CAUTION

When using no. 28 drill bit, do not drill into upper

body (3). Assembly may be damaged.

Using drill and no. 28 drill bit, drill screw holes (5).

NOTE

If tap is not available, use self-tapping screws.

Using tap, tap holes in upper body (3).

Using screwdriver, screw in and tighten four new screws.

END OF TASK

7-251