ACCELERATOR CONTROLS AND LINKAGE REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT.

TM 9-2320-211-20-3-1

4-34. ACCELERATOR CONTROLS AND LINKAGE REMOVAL, REPAIR, REPLACE-

MENT, AND ADJUSTMENT.

l/2-inch wrench (2)

TOOLS: Flat-tip screwdriver

Pliers

3/8-inch wrench (2)

l/2-inch socket wrench

3/8-inch socket wrench

7/16-inch wrench

Cross-tip screwdriver

(Phillips type)

SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Preliminary Procedures.

(1) Open hood. Refer to TM 9-2320-211-10.

(2) Disconnect battery ground cable. Refer to para 7-44.

(3) Remove front cab tunnel cover. Refer to Part 2, para 17-5.

b. Removal.

FRAME 1

Working under truck and using flat-tip screwdriver, loosen screw (1) and take

collar (2) off throttle control wire (3).

Take throttle control wire (3) out of clip (4).

Take offspring(5) from throttle rod assembly(6).

Using pliers, takeout cotter pin (7). Pullout pin (8).

TO FRAME 2

TA 054673

4-168