Section IV. TURBOCHARGER

TM 9-2320-211-20-3-1

4-8. TURBOCHARGER OIL INLET AND OIL DRAIN TUBES REMOVAL AND

REPLACEMENT.

TOOLS: Flat-tip screwdriver

9/16-inch open end wrench

7/8-inch open end wrench

SUPPLIES: None

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Preliminary Procedures.

(1) Open hood. Refer to TM 2320-211-10.

(2) Remove crankcase breather tube. Refer to para 2-5.

b. Removal.

FRAME 1

1. Using 9/16-inch wrench, unscrew two capscrews (l). Take out two capscrews

with washers (2).

2. Using 7/8-inch wrench, unscrew fitting (3),

GO TO FRAME 2