Section III. ENGINE LUBRICATION SYSTEM

TM 9-2320-211-20-3-1

2-4. OIL FILTER ELEMENT REMOVAL AND REPLACEMENT.

TOOLS : 7/16-inch wrench

7/8-inch wrench

Needle nose pliers

SUPPLIES: Container

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

Housing seal

Gasket

Filter element

Lubricating oil, ICE, OE/HDO, MIL-L-2104

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

NOTE

This task is the same for the two oil filter ele-

ments. This task is shown for the rear oil

filter element.

a. Removal.

FRAME 1

NOTE

If engine has been off for 15 minutes or more, do not

drain oil from filter.

Using 7/16-inch wrench, unscrew and take out drain plug (1). Drain oil into

container.

Using 7/8-inch wrench, unscrew center bolt (2) and take out center bolt and

housing (3).

Take out filter element (4) and housing seal (5) and throw them away.

TO FRAME 2