REAR WINCH SHEAR PIN REMOVAL AND REPLACEMENT (MODEL M764).

TM 9-2320-209-10-4

2-12. REAR WINCH SHEAR PIN REMOVAL AND REPLACEMENT (MODEL M764).

TOOLS: P l i e r s

Ballpeen hammer, light

1/4-inch Drift punch

SUPPLIES: Artillery and automotive grease, type GAA, MIL-G-10924

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

Removal.

FRAME 1

Place FRONT TRANSMISSION gear shift lever (1) in N position.

Turn drive sprocket (2) until ends of shear pin (3) can be seen.

Using pliers, take out cotter pin (4) at each end of shear pin (3).

Using drift punch and hammer, drive out shear pin (3). If shear pin was broken

off, using drift punch and hammer, drive out broken pin and any pieces of pin.

END OF TASK