Section III. WHEELS EQUIPMENT ITEMS MAINTENANCE

TM 9-2320-209-10-4

2-5. JACKING PROCEDURE.

NOTE

This task is the same for all wheels. This task

is shown for the left rear-rear wheel.

TOOLS : Hydraulic screw jack with handle

SUPPLIES : Wood block

PERSONNEL: One

EQUIPMENT CONDITION : Truck parked, engine off, handbrake set, wheels

choked.

FRAME 2

Take hydraulic screw jack (1) and handle (2) out of stowage compartment above

l e f t running board.

Put wood block (3) on ground under axle housing (4) and put screw jack (1) on

wood block .

Turn out screw jack (1) until it touches axle housing (4).

Using slotted end of jack handle (2), turn bleeder valve (5) to the right. Put

jack handle in screw jack (1).

Moving jack handle (2) up and down, raise wheel assembly (6) off ground.

END OF TASK