ELECTRICAL AND PNEUMATIC APPLIANCES ASSEMBLY MAINTENANCE

TM 55-1730-223-13

c. Raise the corner of the

platform to be worked on using a

suitable jack placed under the

main frame.

NOTE

Do not use the immobi-

lizing jack integral with

the wheel assembly to be

removed.

d. Loosen tie rod attaching

screw (1) and remove tie rod (2)

(front only). Loosen four wheel

assembly attaching nuts (3).

Remove washers (4 and 5) and

screws (6) and remove wheel

assembly (7) .

e. Straighten bent locking

pins. Weld any cracked suspension

parts. Replace any stripped or

broken nuts or bolts.

f. Place wheel assembly (7) in

position on main frame. Align

holes. Place screws (6) washers

(4 and 5) and nuts (3). Tighten

nuts. Position tie rod (2) on

suspension unit. Attach with

screw (1).

g. Lower corner of platform

with jack.

3-26. ELECTRICAL AND PNEUMATIC APPLIANCES ASSEMBLY MAINTENANCE. The

Electrical and Pneumatic Appliances Assembly consists of outlet boxes

for air and electric power, connecting wire and hoses and attaching

The removal, repair and installation instructions are as

hardware.

follows:

Refer to paragraph 3-27 for removal, repair and installation

of air hose and wire.

3-16