Reassembly. (AVIM)

TM55-1730-215-13 & P

g. Reassembly. (AVIM)

(1) Install O-Ring (10), plunger disk (9) plunger cup (8), grommet

(7) , spreader (6) and stop nut (5) on plunger (3) .

(2) Lightly lubricate plunger assembly (3) and cylinder (11) wall

with clean hydraulic fluid (item 3, Appendix D).

(3) Slide plunger assembly into cylinder, taking care not to

damage plunger cup.

(4) Install spacer (4), plunger wiper (2), and stop nut (1).

h. Installation.

(1) Position cylinder

assembly lower mounting (4) and

attach to outside scissors with

bolt. Do not tighten bolt at

this time.

(2) Swing cylinder assembly

into position and attach

cylinder ram (upper end) (3) to

inside scissors.

(3) Connect hydraulic hose

(1) to fitting on bottom end of

cylinder assembly (2).

3-28