Remove - TM-5-5420-279-230947

TM 5-5420-279-23

NOTE

There are two stabilizer control panels one on each side of the vehicle. This procedure

can be used to replace either stabilizer control panel.

Remove

(1)

Remove the four screws (2) securing the stabilizer control panel cover (3).

(2)

Using the wiring diagram provided at appendix G, note the positions of the wiring to the

stabilizer control panel cover.

(3)

Remove the two electrical cables (1) from the stabilizer control panel.

(4)

Remove the four nuts screws and lock washers securing the stabilizer control panel to the

mounting bracket. Discard the lock washers.

(5)

Check all electrical cables for chafing and damage.

(6)

Check all threaded components for wear and damage.

(7)

Replace components as required.

Install

(1)

Fit the stabilizer control panel to the mounting bracket with four nuts screws and lock

washers.

(2)

Fit the two electrical cables (1) to the stabilizer control panel.

(3)

Connect the wiring to the stabilizer control panel cover (2) in the positions noted during

removal.

(4)

Fit the stabilizer control panel cover (3) with four screws (2).

Follow on tasks

(1)

Switch the battery shutoff switch to the on position.

(2)

Check the operation of the crane.

(3)

Check the operation of the light and switch on the stabilizer control panel.