|
|
TM 5-5420-279-23
This task covers:
a. Remove
b. Install
INITIAL SETUP:
Tools Required
Tool Kit, General Mechanic's, Automotive (GMTK)
Shop Set Contact Maintenance Truck HMMWV
Materials Required
Thread locking compound, loctite 243
Lock washers (Qty 4)
O-ring (Qty 1)
Equipment Conditions
Slide frame deployed
WARNING
SLIP AND FALL INJURY. PERSONNEL MAY SLIP ON SPILLED HYDRAULIC
FLUID. SUITABLE CONTAINERS AND FLUID ABSORBENT MATERIALS ARE TO
BE USED TO CONTAIN SPILLAGE.
a.
Remove
(1)
De-pressurize the hydraulic system. See unit maintenance procedure 5-118.
(2)
Drain the brake assembly (5). See operator's maintenance TM 5-5420-279-10.
(3)
Note the position of and disconnect the hydraulic pipes connected to the hydraulic motor
(1).
(4)
Remove the four bolts (2) and lock washers (3) securing the motor (1) to the brake
assembly (5).
(5)
Note the orientation of and remove the motor (1).
(6)
Remove and discard the o-ring (4).
(7)
Note the position of and remove the hydraulic pipes connected to the rear of the brake
assembly (5).
(8)
Remove the eight bolts (6) securing the brake assembly (5) to the transmission (8).
(9)
Note the orientation of and remove the brake assembly (5).
(10)
Remove the twelve bolts (7) securing the transmission (8) to the crane column.
(11)
Note the orientation of and remove the transmission (8), place on a suitable working
surface.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |