HYDRAULIC SYSTEM - PTO SOLENOID

TM 5-5420-279-23

5 - 137 HYDRAULIC SYSTEM - PTO SOLENOID

This task covers:

a. Remove

b. Install

INITIAL SETUP:

Tools Required

Tool Kit, General Mechanic's, Automotive (GMTK)

Materials Required

Lock washers (Qty 2)

Thread locking compound, loctite 243

Equipment Conditions

Vehicle switched off and battery shutoff switch in the off position

Right hand engine side panels removed for access, see PLS TM 9-2320-364

series

WARNING

SLIP AND FALL INJURY. PERSONNEL MAY SLIP ON SPILLED HYDRAULIC

FLUID. SUITABLE CONTAINERS AND FLUID ABSORBENT MATERIALS ARE TO

BE USED TO CONTAIN SPILLAGE.

Remove

(1)

Remove the military connector and cable (7) attached to the PTO solenoid (1).

(2)

Note the position of and remove the three oil pipes (6, 8 and 9) connected to the PTO

solenoid (1).

(3)

Remove the two screws (2) securing the bracket (5) to the chassis.

(4)

Remove the PTO solenoid (1).

(5)

If required remove the two screws (3) and lock washers (4) securing the PTO solenoid (1)

to the bracket (5). Discard the lock washers (4).

Install

(1)

If removed earlier, fit the bracket (5) to the PTO solenoid (1) with the two new lock washers

(4) and screws (3).

(2)

Apply thread locking compound to the two screws (2).

(3)

Fit the bracket (5) and solenoid (1) to the chassis with the two screws (2).

(4)

Fit the hydraulic pipes (6, 8 and 9) to the positions noted during removal.

(5)

Fit the military connector and cable (7) to the PTO solenoid (1).