|
|
TM 5-5420-279-23
Launch Beam cannot be
Lowered onto Far Bank
CAUTION
The Launch Beam can be
To have reached this
lowered by stepping to the
stage of build, the
Beam Angle function on the
articulator cylinders
chest pack. In this m ode only
have already been
sm all m ovem ents of the
operated when the
joystick are perm itted and
beam angle was set
care m ust be taken to ensure
the beam is not forced down
Operator
onto the far bank.
Tasks
Maintainer
Tasks
Go to hydraulic
Can beam
No
trouble shooting
be lowered in Beam
chapter 2 procedure
Angle m ode. NOTE
2-007
CAUTION
Yes
W ARNING
Conduct electrical checks on the following solenoids:
CRUSH INJURY. BEFORE CARRYING
PV1b- Launching Fram e W inch Control Manifold
OUT TROUBLESHOOTING INVOLVING
SV1- Launching Fram e Articulator Manifold
SV10, A SUSPENDED OR PART BUILT
SV9, SV10, SV16 - Launch Fram e Pilot Manifold
BRIDGE M UST BE M ADE SAFE EITHER
See Resistance Check in Maint Procedure 5-124
BY COM PLETING THE BUILD
OPERATIONS IN BACK-UP M ODE OR BY
RETRIEVING THE BRIDGE.
CRUSH INJURY. A SUSPENDED BRIDGE
W ILL M OVE IF SV10 IS M ANUALLY
Ensure MIMIC panel
OPERATED AND THE CHEST PACK
indications and LED
RIGHT-HAND JOYSTICK IS M OVED
illum ination agree with
FROM THE CENTRAL POSITION
energization chart -
CAUSING ACTIVATION OF OTHER
SOLENOID VALVES.
Yes
Does Launch
Fault cleared
Beam lower in Far
Bank Seat
No
Manually operate SV1
Go to Part
and operate joystick in
2
Far Bank Seat
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |