Click here to make tpub.com your Home Page

Page Title: Test of Attenuator, Fixed CN-1066/URC (Generator Load)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
 Advancement
 Aerographer
 Automotive
 Aviation
 Construction
 Diving
 Draftsman
 Engineering
 Electronics
 Food and Cooking
 Logistics
 Math
 Medical
 Music
 Nuclear Fundamentals
 Photography
 Religion
   
   

 
C2, TM 11-6625-623-45
j. Check that resistance between J1 and P1
c. Set the signal generator for a 2mc, 3
and between J2 and P2 is less than one (1)
volts, output.
ohm.
d. Connect the UG274B/U connector to the
DA340/URC connector associated with the
5-10. Test of Attenuator, Fixed CN-1066/
blue tipjack using the 412inch fabricated
URC (Generator Load)
cable.
(fig.m 3-1 and 4-2)
a. Connect the ZM-4B/U between center
e. Check that the AN/URM-145 indicates
conductors of the CN1066/URC BNC con-
not less than 2.90 volts.
nectors.
f. Set the frequency of the signal generator
b. The ZM-4B/U shall indicate 50 ohms 5;
to 30 mc and disconnect the DA-340/URC
center conductors shall not be shorted to outer
from the UG-274B/U.
conductor or case.
g. Set the signal generator output level to
5-11. Test of Test Probe No. 1
3 volts.
(TM 11-6625-623-12, fig. 1-6)
h. Connect the DA-340/URC to the UG-274
a. Connect the ZM-3/U between center con-
B/U as indicated in d above.
ductors (tip probe to center of BNC connector.
b. The ZM-3/U shall indicate 100 mmf 10
i. The AN/URM-145 shall indicate 2.2 volts
mmf.
0.11.
17

Privacy Statement - Press Release - Copyright Information. - Contact Us

 Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business