Section I. INTRODUCTION - TM-11-6625-1610-24P0005

TM 11-6625-1610-24P

SECTION I

INTRODUCTION

1. Scope

Code

Definition

This manual hats spares and repair parts; special

PA-Item procured and stocked for anticipated or

tools; special test, measurement, and diagnostic

known usage.

equipment (TMDE), and other special support

XD-A support item that is not stocked. When

required

equipment

for

p e r f o r m a n c e of

required, item will be procured through

organizational, direct support and general support

normal supply channels.

maintenance of the MK-1035/ARC-131.

NOTE

It authorizes the requisitioning and issue of spares

Cannibalization or salvage may be

and repair parts as indicated by the source and

used as a source of supply for any

maintenance codes.

items source coded above except

t h o s e coded XA and aircraft

2. General

support items as restricted by AR

This Repair Parts and Special Tools List is divided

700-42.

into the following sections:

(2) Maintenance code. Maintenance codes are

a. Section II. Repair Parts List. A list of spares

assigned to indicate the levels of maintenance

and repair parta authorized for use in the per-

authorized to USE and REPAIR support items.

formance of maintenance. The list also includes

The maintenance codes are entered in the third and

parts which must be removed for replacement of

fourth positions of the Uniform SMR Code format

the authorized parts. Parts lists are composed of

as follows:

functional groups in numeric sequence, with the

(a) The maintenance code entered in the

parts in each group listed in figure and item

third position will indicate the lowest maintenance

number sequence.

level authorized to remove, replace, and use the

b. Section III. Special Tools List. Not ap-

support item. The maintenance code entered in the

plicable .

third position will indicate one of the following

c. Section IV. National Stock Number and Part

levels of maintenance:

Number Index. A list, in National item iden-

tification number (NIIN) sequence, of all National

Application/Explanation

Code

stock numbers ( NSN) appearing in the listings,

O Support item is removed, replaced, used at the

followed by a list, in alphameric sequence, of all

organizational level.

part numbers appearing in the listings. National

F Support item is removed, replaced, used at the

stock numbers and part numbers are cross-

direct support level.

-referenced to each illustration figure and item

D Support items that are removed, replaced,

number appearance.

used at depot, mobile depot, specialized

repair activit y only.

3. Explanation of columns

(b) The maintenance code entered in the

a. Illustratwn. This column is divided as

fourth position indicates whether the item is to be

follows:

repaired and identifies the lowest maintenance level

Indicates the figure

(1) Figure number.

with the capability to perform complete repair (i.e.,

number of the illustration on which the item is

all authorized maintenance

functions). This

shown.

position will contain one of the following main-

(2) Itern number. The number used to identify

tenance codes:

item called out in the illustration.

b. Source, Maintenance,

and Recoverability

Application/Explanation

Code

(SMR) Codes.

F- the lowest maintenance level capable of

(1) Source code. Source codes indicate the

complete repair of the support item is the

manner of acquiring support items for main-

direct support level.

tenance, repair, or overhaul of end items. Source

D- The lowest maintenance level capable of

codes are entered in the first and second positions

complete repair of the support item is the

of the Uniform SMR Code format as follows:

depot level.

Z - Non reparable. No repair is authorized.